Description

Hello and thanks for checking out my grips! These grips dubbed "The Racer" were based on a customer request, and turned out to be quite nice! They draw inspiration from S&W aftermarket grips with a forward sweep to the lower arch. These are my first adaptation of my magnum grips "AMRAP" that fills in the dead space behind the trigger and improves overall hand placement on these tiny little guns. I have also played around with face inlays and landed on a shallow slotted design that I think compliments the gun rather well. More face designs are in the works and will be added to the listing in the near future! These are also quite a bit thinner than the rest of my current grips shaving almost 5mm of total width off of the frame allowing for ultimate concealment. They measure 17.2mm wide overall, and add roughly 16mm or 5/8" of extra room for another finger. The grips are held into the frame with a tight tolerance inlay and a single alloy black M3 x 12mm hex cap screw and nut. Included and recommended for use is a small internal spacer that will sit on the screw inside of the grip to keep from overtightening and possibly damaging the grips. Keep in mind that not every NAA was created equal, please allow for some tolerance difference, you may have a small amount of slop, or you may need to clearance the grips a tad to get your perfect fit. 99% of the time, this is not the case and the grips fit great with no modification necessary. Colors listed are subject to change at any time - colors may not be exact to image representation but I will do my best to keep them as uniform as possible. Brands, prices, and color recipes change unfortunately. If you have any suggestions or are wanting a closer look at a specific color, feel free to send me a message! Thanks for checking out the latest from AeroLayer!