Description

New Cylinder Blast line grip available! The Anvil for Magnum frames! These grips are designed with extra material on the backstrap allowing the grip to fill out the hand better while still keeping the mini revolver forward in the hand. The rounded back corner keeps the grip comfortable in the palm allowing for a strong hold. Extra material under the butt on the grip for an extra finger to fit. Grip features the Cylinder Blast tabs up the side of the frame meeting with the back of the cylinder to prevent unwanted snags when drawing. It also adds a nice thumb shelf to the frame and helps to draw the revolver better into your hand. Grips are held together with a M3 x 12mm black alloy screw and nut (stainless hardware available upon request) and are fully ambidexterous. Use the included grip spacer along with the grip to prevent over-tightening and bowing when installed. ** GRIPS WILL NOT FIT SIDEWINDER OR SENTINEL MODELS ** Due to the decreased thickness of these grips, there is not enough room for cutouts in the CB tabs to clear the existing cylinder backing material on the frames of the Sidewinder and Sentinel. Grips will still fit and function fine on Ranger II and other top-break models. Grips are printed to a close tolerance and should fit great on 99% of frames without trouble. Occasionally I run into a frame that is old/out of standard spec that may need a small bit of fitting to seat perfectly. Please reach out if that is the case, and we can work together to get them fit up for you! Colors subject to change at any time - colors may not be exact to image representation but I will do my best to keep them as uniform as possible. Brands, prices, and color recipes change unfortunately. If you have any suggestions or are wanting a closer look at a specific color, feel free to send me a message!